Print Out; Preparation For Printing; Print Out In Normal Mode - Kanomax Climomaster S-6531-0E User Manual

§ 7

Print Out

Preparation for Printing

Connect the printer cable to the Serial
Communication terminal located on
the side of the instrument to print out
measurement data.
<Requirements>
●Printer (optional)......Recommended: Seiko Instruments Model
●Printer Cable (optional)
<Check the BAUD RATE>
You need to enter the same baud rate and data transmission
conditions on both the Main Body and the printer.
The factory setting of the Main Body is as follows:
<Connecting the Printer>

Print Out in NORMAL Mode

■ Humidity is only
available on
MODEL6531/6533.
■ Air temperature is
only available on
MODEL6531/6541
*
/6542/6533/6543/
6561.
the lower left of the display.
Examples of Print Out
■ Pressure is only
available on
MODEL6501-B0
/-C0.
34 Print Out
actoolsupply.com
DPU-S245
Data Bit Length
Parity
Set Value
Baud Rate
Stop Bit
1. Connect the printer to the Main Body (Serial Communication
Terminal) using the printer cable.
2. Turn ON the CLIMOMASTER first, and then turn the printer ON.
3. Make sure that the CLIMOMASTER is displaying NORMAL Mode.
'12/04/12a15:40:23 ~
0.87f
TCC1
HOLD
25.3e
64.1g
If the printer is not connected properly, "PERR" will be displayed in
Air Velocity Mode
2001/06/19 13:42:09
Velocity 0.12 m/s
Temperature 25.9 ﾟ C
Humidity 62.7 %RH
actoolsupply.com
Communication
Terminal
*To change the BAUD RATE, refer to
8 bits
"Units and Baud Rate" on P. 46.
None
*To configure the settings of the
＊
printer, refer to the printer operation
manual.
1
When the screen is displaying in
NORMAL Mode, press
display. Press
on the screen.
2001/06/19 13:42:28
...Air Velocity
Pressure
...Air Temperature
...Humidity
Serial
to HOLD the
to print out the data
Pressure Mode
0.23 kPa