Connecting The Probe Fixing Jig - Kanomax 1580 User Manual

Connecting the probe fixing jig

Only the probes 0976-03 and 0976-04, 0976-13, 0976-14 can be used to anchor the

probes with the probe fixing jig. Do not use any other probe. Otherwise, malfunction or
damage may occur.
How to mount/remove the probe to/from the fixing jig, follow the procedure below.
When mounting/removing the probe, do not allow the sensor of the probe to touch the
probe fixing jig or surrounding objects. Do not touch the sensor of the probe with your
hand. Otherwise, malfunction or damage may occur.
■Mounting the probe
Place the part of the probe, which is in the red frame as the figure below, on the probe
fixing jig and push the probe until you feel a click.
■Removing the probe
Hold the part of the cable, which is in the red frame as the figure below, and move the
holding part of the cable in the direction of the probe sensor (left photo). After that, hold
the part of the probe, which is in the red frame, and pull up the holding part from the
probe fixing jig to remove (right photo).
The mounting angle can change due to the probe tension.
If its angle changes, adjust the mounting angle if needed.