Running Online Diagnostic Tests
This example shows how to start a diagnostic test by using the test name:
Switch# diagnostic start switch 2 test TestInlinePwrCtlr
This example shows how to start all of the basic diagnostic tests:
Switch# diagnostic start switch 1 test all
Displaying Online Diagnostic Tests and Test Results
You can display the online diagnostic tests that are configured for the switch or switch stack and check
the test results by using the privileged EXEC show commands in
Table 48-1
Commands for Diagnostic Test Configuration and Results
Command
show diagnostic content switch [number | all]
show diagnostic status
show diagnostic result switch [number | all]
test {name | test-id | test-id-range | all} [detail]]
show diagnostic switch [number | all]
show diagnostic schedule switch [number | all]
show diagnostic post
1. The switch [number | all] parameter is supported only on stacking-capable switches.
For examples of the show diagnostic command output, see the "Examples" section of the show
diagnostic command in the command reference for this release.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
48-6
Purpose
1
Display the online diagnostics configured for a switch.
Display the currently running diagnostic tests.
1
[detail |
Display the online diagnostics test results.
1
[detail]
Display the online diagnostics test results.
1
Display the online diagnostics test schedule.
Display the POST results. (The output is the same as the show post
command output.)
Chapter 48
Configuring Online Diagnostics
Table
48-1:
OL-12247-04