S.R.Smith TURBOTWISTER Assembly And Installation Instructions Manual page 17

8. Drive the assembled Wedge Anchors (12) through the slide mounting holes until the Wedge Anchor
Flat Washers are flush with the slide's surface material, as shown in Figure P.
9. Ensure the Slide Ladder is plumb by placing a level on a Ladder tread. If necessary, shims can be
provided by S.R. Smith to place beneath the base of the Ladder to ensure it is plumb due to varying
deck slopes. Call S.R. Smith at 800-824-4387 if shims are needed.
10. Expand the Wedge Anchor Stud (12) by tightening the Wedge Anchor Hex Nut (12) 3 to 5 turns.
Once the Wedge Anchor (12) is set, remove Wedge Anchor Hex Nut (12) and install a 1/2" Lock
Washer (3) between the Wedge Anchor Flat Washer (12) and Hex Nut (12).
11. Then retighten the Hex Nut (12) to a torque of 25 ft.-lbs. (33.9 N-m). See Figure Q for final assembly.
Figure P
Figure Q
17