S.R.Smith TURBOTWISTER Assembly And Installation Instructions Manual page 10

5. Install four 3/8" x 2-1/2" Studs (8) into the threaded inserts located at the top of the ladder as shown in
Figure G.
6. Assemble the Top and Bottom Ladder Sections as shown in Figure H, Figure I, and Figure J. Do not
fully tighten fasteners until all the hardware is in place. The hardware required for the connections
shown in Figure H are as follows: 3/8" x 2-1/4" Button Head Cap Screw (6) and 3/8" Flat Washer (4).
Figure G
Figure H
10