S.R.Smith TURBOTWISTER Assembly And Installation Instructions Manual page 9

3. Once the sidewall connections have been made, remove the assembled Exit and Middle Slide
Sections from the Pedestal. Turn the assembly upside down and fasten the underside as shown in
Figure E. The required hardware is as follows: 3/8" x 6" Hex Head Cap Screw (11), 3/8" Flat Washer
(4), 3/8" Flat Washer (4), 3/8" Lock Washer (2), and 3/8" Hex Nut (1).
4. Attach the Pedestal to the Middle Runway Section and Exit Slide Sections. Install the fasteners, as
shown in Figure F. The required hardware is as follows: 3/8" x 3-1/2" Lag Screw (9), and 3/8" Flat
Washer (4).
Figure E
Figure F
9