Assembly Instructions; Tools Required; Gasket Installation - S.R.Smith TURBOTWISTER Assembly And Installation Instructions Manual

Tools Required

1. Ratchet handle
2. 9/16" deep socket
3. 9/16" wrench
4. 3/4" socket or wrench
5. 7/32" Allen wrench
6. Phillips head screwdriver
7. 1/2"Ø (12.7 mm) concrete drill bit

Gasket Installation

•
Most of the gasket material has been installed at the factory, however additional gasket has been
provided in case any gasket has fallen off during shipping. If gasket installation is required, follow
the instructions below in Figure B. The gasket on the face of the ladder is not installed in the
factory, but detailed instructions are provided on page 12, Figure K.
•
Apply gasket in the required locations as shown in Figure B.
•
Place gasket along the section to determine the length needed.
•
Cut gasket to appropriate length.
•
Remove backing and adhere gasket to slide.
•
All gaskets below are applied as shown in Figure B in the Joint / Gasket Cross-Section Detail.
•
See page 12, Figure K, for further details on installing the ladder gasket, PN 8-531.

ASSEMBLY INSTRUCTIONS

Figure B
6
8. 1/4"Ø (6.3 mm) drill bit
9. Power drill
10. PVC pipe primer & glue
11. Anti-seize
12. Saw to cut PVC pipe
13. Knife
14. Level