Water System Assembly - S.R.Smith TURBOTWISTER Assembly And Installation Instructions Manual

Note: It's a good idea to dry fit all of the plumbing parts before gluing them together so you
can make adjustments accordingly.
1. Temporarily assemble the two lengths of 1-1/2"Ø Flex Hose (18) and (19) to the 1-1/2"Ø Ball Valve
(20). Then insert the 1-1/2"Ø Coupling (21) to the opposite end of the longer 1-1/2"Ø Flex Hose (18),
as shown in Figure R.
2. Make alignment marks on the parts with a pencil before disassembling. This will aid in reassembling
the parts while gluing them together.
3. Use PVC primer and glue to reassemble the plumbing parts.
4. Fasten the two 1-1/2"Ø Pipe Clamps (17) to the slide using #14 x 1" Pan Head Tapping Screws (15),
as shown in Figure S.

WATER SYSTEM ASSEMBLY

Figure R
Figure S
19