Page 1
TURBOTWISTER® SLIDE OWNER’S MANUAL S.R. SMITH TURBOTWISTER SLIDES ARE MANUFACTURED FOR INSTALLATION AND USE ON RESIDENTIAL INGROUND SWIMMING POOLS ONLY. THE TURBOTWISTER IS NEVER TO BE INSTALLED AND USED ABOVEGROUND POOLS, ONGROUND POOLS, HOUSEBOATS, BOAT DOCKS, FLOATING DOCKS OR PLATFORMS OR OTHER BODIES OF WATER SUCH AS LAKES, PONDS, RIVERS, ETC.
SLIDE WARNING AND SAFETY SUMMARY DANGER – FAILURE TO FOLLOW THESE WARNINGS, INSTRUCTIONS, AND THE OWNER’S MANUAL MAY RESULT IN SERIOUS INJURY OR DEATH DO NOT SLIDE HEAD FIRST HEAD FIRST SLIDES ARE STRICTLY PROHIBITED TO REDUCE THE POSSIBILITY OF INJURY, IT IS NECESSARY THAT THE USER KNOW THAT THE CHIEF DANGER OF HEAD FIRST SLIDING IS SERIOUS SPINAL INJURY.
S.R. Smith Turbotwister slides are designed and manufactured for installation and use on inground swimming pools only. S.R. Smith Turbotwister slides are NEVER to be installed and used on aboveground pools, onground pools, houseboats, boat docks, floating docks or platforms, or other bodies of water such as lakes, ponds, rivers, etc 1.
Read, understand and enforce all safety and use instructions on the slide. DAILY/WEEKLY MAINTENANCE OF THE TURBOTWISTER 1. When hosing down the deck, hose your Turbotwister to wash away any dust, dirt or other debris, which may have accumulated. 2. Be sure that all connections are secure. Tighten hardware if necessary.
APPLICABLE STANDARDS AND CODES All S.R. Smith Turbotwister slides are manufactured in accordance with Consumer Products Safety Commission STANDARD FOR SWIMMING POOL SLIDES, 16 CFR Ch. 11 Part 1207 (latest edition). The installation of this slide must comply with all applicable governmental and building codes.
HAVE BEEN FOLLOWED BY THE INSTALLER. 1. The critical dimensions for placement of the Turbotwister are as shown in FIGURE B and FIGURE C A. The slide exit runway surface shall not exceed 20” (508 mm) above the water surface as shown in FIGURE B.