Advertisement
Install the Retractors
Retractors can be installed in a vertical, angular, or horizontal orientation. No adjustment of the enclosure screws is needed if the
retractors are mounted vertically. To mount at an angle or horizontally, adjust the enclosure screws as shown below. When the
retractors are mounted horizontally, the retractor mechanism must be secured to the underside of the table (see Cable Retractor
Setup Guide, which is available at www.extron.com).
To secure the retractors in the retractor bracket, follow the instructions in figure 9.
2
Insert the pin through the
Retractor mounting hole on
the side of the Cable Cubby
and Retractor assembly.
1
Insert Retractors into
the Retractor bracket.
Installing Retractors
Figure 9.
Route and Connect the Cables to Cable Cubby
Route and Connect AV Cables
Figure 10.
3
Secure the clip
on the pin.
4
Secure the locking screw
on each Retractor. Do not
overtighten.
3
Connect cables to the AV system
and connect the AC power cord.
NOTE: Ensure there is no tension
on the power cable.
2
Using zip ties, secure cables to the holes
on the bottom of the Cable Cubby.
1
For cable pass-through applications,
allow at least 36 inches (0.9 m) of cable
loop for each cable.
Product Category
Horizontal Mounting
Remove two enclosure screws
(one on each side) from this position.
Then mount the Retractors as shown
at left.
See the Cable Retractor Setup Guide, available
at www.extron.com, for additional steps.
Angular Mounting
Remove the two enclosure screws, as shown
above, and then follow this step:
Move the cable release assembly upward until
the angular mounting hole is visible. Reinstall the
enclosure screws in this hole (both sides).
CAUTION:
Risk of Electric Shock.
This equipment must be grounded.
ATTENTION :
Risque de choc
électrique. Cet équipement doit
être fixé au sol.
Cable Release
Assembly
7
Advertisement
