Advertisement
EBP 1200C • Setup Guide (Continued)
Mounting the EBP 1200C
A variety of modules allow you to populate the Cable Cubby enclosure with a combination of AAPs, cable pass-through,
retractors, or power modules. The EBP 1200C accommodates your choice of any two modules, allowing you to customize the
device to meet your specific needs.
Assemble the Connectivity Modules of your Choice
The EBP 1200C is provided with a single connectivity bracket that can be used with either the AAP frame plate or the cable
grommet plate. Follow the steps below to assemble the connectivity modules of your choice before they can be mounted into the
EBP 1200C.
1
Secure up to three single-space
AAP module
AAPs in the AAP plate.
The AAP module accommodates up to three single-space AAPs.
1
Secure up to three single-space
AAPs in the AAP plate.
#4-40 Nut with
Captive Washer
#4-40 Nut with
Captive Washer
Assembling the AAP Module
Figure 3.
NOTE:
After assembling the AAP module, proceed to
Cable pass-through module
The cable pass-through module accommodates up to eight AV cables.
1
Insert cables through the bottom of
the connectivity bracket and into the
holes of the grommet plate.
You may need to bend the
1
Insert cables through the bottom of
plate gently to slide the cable
the connectivity bracket and into the
past the slot opening.
holes of the grommet plate.
2
You may need to bend the
Secure the grommet plate on the
plate gently to slide the cable
connectivity bracket, using four
past the slot opening.
of the provided module screws.
2
Secure the grommet plate on the
connectivity bracket, using four
of the provided module screws.
Assembling the Cable Pass-through Module
Figure 4.
Install the Modules
Determine where the modules are installed in the Cable Cubby. Any combination of two modules can be installed. The modules
can be installed on either side of the enclosure and at various heights.
NOTES:
•
Ensure that there is enough room above the modules for the Cable Cubby lid to close completely.
•
Use a screwdriver to secure the modules with the screws.
4
3
Secure the AAP plate on the connectivity brackets,
using four of the provided module screws.
3
Secure the AAP plate on the connectivity brackets,
using four of the provided module screws.
2
Insert cables through the bottom of the connectivity bracket.
Connect cables to the AAPs.
2
Insert cables through the bottom of the connectivity bracket.
Connect cables to the AAPs.
Install the Modules
3
Snap the included
hole plugs into any
unused holes.
3
Snap the included
hole plugs into any
unused holes.
below.
Advertisement
