Advertisement
EBP 1200C • Setup Guide (Continued)
Mount the EBP 1200C
TIP:
Before mounting the EBP 1200C, you should set the eBUS ID address, since this requires access to the DIP switches,
which are on the bottom of the unit (see
Insert the EBP 1200C enclosure into
the table
CAUTION:
The flanged edges of the top
of the surface enclosure are sharp.
These edges are also soft and may be
easily nicked or bent. Exercise caution
when handling the enclosure to prevent
personal injury or damage to the
enclosure.
ATTENTION :
Les extrémités à brides
du haut de la surface du boîtier sont
aiguisées. Ces extrémités sont aussi
lisses et peuvent facilement être coupées
ou pliées. Soyez prudents lorsque vous
manipulez le boîtier afin d'éviter de
l'endommager ou de vous blesser.
Under the Table, Adjust the Side Clamps on the Enclosure
Lever
1
Rotate the side clamp
outward and ensure
that the lever is down.
Secure the Cable Cubby Enclosure
Figure 8.
6
Setting the eBUS ID Address
1
Remove the plastic strips and
lm on the surface of the
Cable Cubby.
2
Ensure that the
side clamps are
seated against the
enclosure.
Insert EBP 1200C Enclosure into the Table
Figure 7.
1
1
2
Slide the clamp all the
way up against the
bottom of the table.
on page 10).
astic strips
and
d d
face of the
he
NOTE:
To lower the side clamp, turn the lever down,
then press and hold the locking plate while sliding
down the clamp.
Locking
plate
3
Ensure the Cable Cubby
is rmly seated in the table.
Raise the lever to secure
the Cable Cubby.
3
Lower the Cable Cubby
into the hole to test the t.
If necessary, carefully
enlarge the opening.
Advertisement
