Overflow-Replace (Igmp Snooping View); Report-Aggregation (Igmp Snooping View) - HP A5120 EI Series Command Reference Manual

[Sysname-igmp-snooping] max-response-time 5

overflow-replace (IGMP snooping view)

Syntax
overflow-replace [ vlan vlan-list ]
undo overflow-replace [ vlan vlan-list ]
View
IGMP snooping view
Default level
2: System level
Parameters
vlan vlan-list: Specifies one or multiple VLANs. You can provide up to 10 VLAN lists. For each list, you
can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to end-
vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a VLAN ID
is 1 to 4094.
Description
Use the overflow-replace command to enable the multicast group replacement function globally.
Use the undo overflow-replace command to disable the multicast group replacement function globally.
By default, the multicast group replacement function is disabled.
This command works only on IGMP snooping–enabled VLANs.
If you do not specify any VLAN, the command takes effect in all VLANs. If you specify a VLAN or
multiple VLANs, the command takes effect in the specified VLANs only.
Related commands: igmp-snooping overflow-replace.
Examples
# Enable the multicast group replacement function globally in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] overflow-replace vlan 2

report-aggregation (IGMP snooping view)

Syntax
report-aggregation
undo report-aggregation
View
IGMP snooping view
Default level
2: System level
Parameters
None
30