Table of Contents
Advertisement
Preparing for installation
Safety recommendations
WARNING!
Before installation and operation, read all of the safety instructions in the
supplied with your router.
General safety recommendations follow:
Turn off all power and remove all power cables before opening the chassis.
•
Unplug all power and external cables before moving the chassis.
•
•
Before installation, locate the emergency power switch so that you can shut off power
immediately if necessary.
Always wear an ESD-preventive wrist strap when installing the device.
•
Do not stare into an open optical interface. The light can cause permanent eye damage.
•
•
Use a good grounding system. This is essential for reliable operation.
Confirm that the resistance between the chassis and the ground is less than 1 ohm.
•
European Union Commission Regulation 1275/2008
The power data for affected products—including the power consumption of the product in networked
standby if all wired network ports are connected and all wireless network ports are activated—is
provided in section P14, "Additional information," of the product IT ECO Declaration available
at http://www.hp.com/hpinfo/globalcitizenship/environment/productdata/iteconetworking.html.
Site requirements
The router can only be used indoors.
This section provides information about temperature, humidity, cleanness, and air quality requirements,
as well as rack-mounting requirements and protection against damage from lightning and EMI.
Table 2 Temperature and humidity requirements
Temperature
0°C to 45°C (32°F to 113°F)
Relative humidity
5% to 90%
6
Compliance and Safety Guide
Advertisement
Table of Contents
