Connecting The Touch 10 User Interface - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80
Contents

Connecting the Touch 10 user interface

In order to use Touch 10 as user interface for the SX80
codec, Touch 10 must either be directly connected to the
codec as described on this page, or paired to the codec via
LAN as described on the next page. The latter is referred to
as remote pairing.
Connecting Touch 10 directly to the codec
Connect Touch 10 to the codec's 2 nd or 3
connector as illustrated.
Note that SX80 does not provide Power over Ethernet (PoE),
so you need a mid-span PoE injector to power Touch 10.
Touch 10 set-up
Once Touch 10 is connected to power, the set-up procedure
begins. Follow the instructions on screen.
If Touch 10 needs software upgrade, new software will
be downloaded from the codec and installed on the unit
automatically as part of the set-up procedure. Touch 10
restarts after the upgrade.
You can verify that Touch 10 is successfully connected to the
codec by checking that the codec address is displayed in the
top banner.
D15105.05 SX80 Administrator Guide TC7.3, OCTOBER 2015.
Introduction Web interface
(page 1 of 3)
About the SX80 network ports
SX80 has three network ports. Network port 1 is reserved for
the connection to LAN, while Network ports 2 and 3 should
be used for peripherals like cameras and Touch 10.
rd Ethernet
Power
• 100-240 VAC
• 50/60 Hz
System settings
If you have more than two peripheral units requiring an
Ethernet connection, you can insert an Ethernet switch
between Network port 2 or 3 and the peripherals.
SWITCH
PoE
injector
AP
Codec address
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
129
Administrator Guide
Setting passwords Appendices Appendices
Standard Ethernet cable
PoE rated Ethernet cable
The Ethernet connector
is behind the lid at the
rear of Touch 10.