Cisco TelePresence SX80 Administrator's Manual page 89

Cisco TelePresence SX80
Contents
Network [1..1] RemoteAccess Allow
Define which IP addresses (IPv4/IPv6) are allowed for remote access to the codec from SSH/
Telnet/HTTP/HTTPS. Multiple IP addresses are separated by a white space.
A network mask (IP range) is specified by <ip address>/N, where N is 1-32 for IPv4, and N is
1-128 for IPv6. The /N is a common indication of a network mask where the first N bits are set.
Thus 192.168.0.0/24 would match any address starting with 192.168.0, since these are the first
24 bits in the address.
Requires user role: ADMIN
Value space: <S: 0, 255>
Format: String with a maximum of 255 characters.
Example:
Network 1 RemoteAccess Allow: "10.11.2.3 192.168.0.0/24 2001:0db8:0000:0000:0
000:ff00:0042:8329 2001:db8:abcd:0012::0/64"
Network [1..1] VLAN Voice Mode
Set the VLAN voice mode. The VLAN Voice Mode will be set to Auto automatically if you have
Cisco UCM (Cisco Unified Communications Manager) as provisioning infrastructure. Note that
Auto mode will NOT work if the NetworkServices CDP Mode setting is Off.
Requires user role: ADMIN
Value space: <Auto/Manual/Off>
Auto: The Cisco Discovery Protocol (CDP), if available, assigns an id to the voice VLAN. If
CDP is not available, VLAN is not enabled.
Manual: The VLAN ID is set manually using the Network VLAN Voice VlanId setting. If CDP is
available, the manually set value will be overruled by the value assigned by CDP.
Off: VLAN is not enabled.
Example:
Network 1 VLAN Voice Mode: Auto
Network [1..1] VLAN Voice VlanId
Set the VLAN voice ID. This setting will only take effect if VLAN Voice Mode is set to Manual.
Requires user role: ADMIN
Value space: <1..4094>
Range: Select a value between 1 and 4094.
Example:
Network 1 VLAN Voice VlanId: 1
D15105.05 SX80 Administrator Guide TC7.3, OCTOBER 2015.
Introduction Web interface System settings System settings
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
89
Administrator Guide
Setting passwords Appendices