What's New In This Version - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80
Contents

What's new in this version

This section provides an overview of the new and changed
system settings and new features in the TC7.3 software
version.
Software release notes
For a complete overview of new features and changes, we
recommend reading the Software Release Notes (TC7). Go
to:
► http://www.cisco.com/c/en/us/support/collaboration-
endpoints/telepresence-quick-set-series/tsd-products-
support-series-home.html
Software download
For software download go to:
► http://www.cisco.com/cisco/software/navigator.html
D15105.05 SX80 Administrator Guide TC7.3, OCTOBER 2015.
Introduction Introduction Web interface
New features and improvements
Local preview of presentation in a call
This allows the user to preview the presentation locally before
sharing it with far end. The feature has previously been
available for EX systems, and is now available across the
portfolio.
Multiple presentation outside a call
When the system is not in a call, it can simultaneously display
multiple external sources on the connected screens, for
example from two laptops.
Feature updates
Several feature improvements have been added to better
align with C series functionality. There is now support for:
• H323 / SIP dual registration
• MultiWay
• Additional audio call
Snap to Whiteboard feature
It is possible to configure a set up for a whiteboard scenario
when using the SpeakerTrack 60.
When the system detects a person speaking close to a
whiteboard, the camera will go to a pre-defined preset
covering the whiteboard area as defined by the administrator
or installer.
There is a setup wizard for the Snap to Whiteboard feature in
the administrator settings on the Touch 10.
System settings
TC7.3.0-TC7.3.2: Users are notified when snapshots are
taken
Both the on screen display and web interface have warnings
when the snapshots feature is enabled. A notification pops up
on the on screen display, when a snapshot is taken. On the
web interface the administrator is warned that this notice will
show up when the feature is enabled.
The system also logs when snapshots are taken, and which IP
address the request was initiated from.
It is possible to allow and disallow snapshots remotely, but
not to observe the room without the users being notified.
TC7.3.3 and later: Remote Monitoring option key
Due to security reasons, taking snapshots of local and far end
video streams from the call control page on the system's web
interface now requires an option key to be installed on the
endpoint.
The remote monitoring option key can only be added to
systems that are upgraded to TC7.3.3 and above. Remote
monitoring is enabled once the option key is added, and the
system rebooted. Once this feature is enabled, the only way
to disable it is to remove the option key.
This feature does not display warning messages or indicators
on the local system that someone is monitoring the room.
Please provide adequate notice to users of the system that
the system administrator may monitor and control the camera
and screen.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
6
Administrator Guide
Setting passwords Appendices