Cisco TelePresence SX80 Administrator's Manual page 68

Cisco TelePresence SX80
Contents
Cameras SpeakerTrack ConnectorDetection Mode
This setting applies only when a Cisco TelePresence SpeakerTrack 60 camera is connected to
the codec (video system).
Determine whether to automatically detect or manually configure which video input each
individual camera is connected to. You should choose manual configuration in situations where
the codec does not receive EDID information from the cameras. Typically, this will be when you
use HDMI repeaters that do not pass on EDID information.
Requires user role: USER
Value space: <Auto/Manual>
Auto: Automatically detect which video inputs the cameras are connected to.
Manual: Manually define which video inputs the cameras are connected to. Use the
Cameras SpeakerTrack ConnectorDetection CameraLeft and Cameras SpeakerTrack
ConnectorDetection CameraRight settings.
Example:
Cameras SpeakerTrack ConnectorDetection Mode: Auto
Cameras SpeakerTrack ConnectorDetection CameraLeft
This setting applies only when a Cisco TelePresence SpeakerTrack 60 camera is connected
to the codec (video system). Furthermore, Cameras SpeakerTrack ConnectorDetection Mode
must be set to Manual.
Enter the number of the video input that SpeakerTrack 60's left camera is connected to. For
example, set to 1 if the left camera is connected to video input 1.
Requires user role: USER
Value space: <1..5>
Format: Select a valid video input number.
Example:
Cameras SpeakerTrack ConnectorDetection CameraLeft: 1
D15105.05 SX80 Administrator Guide TC7.3, OCTOBER 2015.
Introduction Web interface System settings System settings
Cameras SpeakerTrack ConnectorDetection CameraRight
This setting applies only when a Cisco TelePresence SpeakerTrack 60 camera is connected
to the codec (video system). Furthermore, Cameras SpeakerTrack ConnectorDetection Mode
must be set to Manual.
Enter the number of the video input that SpeakerTrack 60's right camera is connected to. For
example, set to 2 if the right camera is connected to video input 2.
Requires user role: USER
Value space: <1..5>
Format: Select a valid video input number.
Example:
Cameras SpeakerTrack ConnectorDetection CameraRight: 2
Cameras SpeakerTrack Whiteboard Mode
This setting applies only when a Cisco TelePresence SpeakerTrack 60 camera is connected to
the codec.
Determine whether to enable the Snap to Whiteboard feature or not.
The Snap to Whiteboard feature relies on a speaker track camera. When a presenter is standing
next to the whiteboard, the camera will capture both the presenter and the whiteboard if the
Snap to Whiteboard feature is enabled. If the feature is disabled, only the presenter will be
captured.
The Snap to Whiteboard feature is set up from the Touch controller.
Requires user role: ADMIN
Value space: <Off/On>
Off: The Snap to Whiteboard feature is disabled.
On: The Snap to Whiteboard feature is enabled.
Example:
Cameras SpeakerTrack Whiteboard Mode: Off
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
68
Administrator Guide
Setting passwords Appendices