Cisco TelePresence SX80 Administrator's Manual page 15

Cisco TelePresence SX80
Contents
About snapshots and remote
monitoring (TC7.3.0 to TC7.3.2)
Snapshots of local input sources
If the snapshot feature is enabled on the video system,
snapshots of the video system's input sources are displayed
on the Call Control page.
Snapshots are displayed both when the video system is idle,
and when in a call.
This feature may be used when administering the video
system from a remote location, for example to check the
camera view and control the camera.
The users of the video system are notified when the
snapshot feature is in use. A notification saying that
the administrator is visually monitoring the room is
displayed on the main display of the video system.
Far end snapshots
If the snapshot feature is enabled on the video system, far
end snapshots may also be captured. Whether or not the
snapshot feature is enabled on the far end video system,
does not make any difference.
Far end snapshots are prohibited during encrypted calls.
D15105.05 SX80 Administrator Guide TC7.3, OCTOBER 2015.
Introduction Web interface Web interface
Navigate to: Call Control
Enable the snapshot feature
By default, the snapshot feature is disabled.
Enable the feature using the web
• Go to the
Configuration
• Navigate to
choose On.
• Click Save
System settings
interface.
Configuration tab and select System
Video > AllowWebSnapshots and
for the change to take effect.
15
Administrator Guide
Setting passwords
View snapshots from the input sources
Click in this area to view snapshots from the
selected main source or presentation source.
Snapshots of the main or presentation source
are displayed for approximately 10 seconds.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Appendices