Cisco TelePresence SX80 Administrator's Manual page 64

Cisco TelePresence SX80
Contents
Audio Input Microphone [1..8] Level
Define the audio level of the Microphone input connector.
See the Audio Level table in the Physical Interface Guide for the codec for a complete overview
of the values represented in dB.
Requires user role: ADMIN
Value space: <0..70>
Range: Select a value between 0 and 70, in steps of 1 dB.
Example:
Audio Input Microphone 1 Level: 58
Audio Input Microphone [1..8] Mode
Set the audio input microphone mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the microphone connector.
On: Enable the microphone connector.
Example:
Audio Input Microphone 1 Mode: On
Audio Input Microphone [1..8] Type
The microphone connectors are intended for electret type microphones. The microphone
connector can be set to line or microphone mode.
Requires user role: ADMIN
Value space: <Microphone/Line>
Microphone: Select Microphone when you have 48 V Phantom voltage and the pre-
amplification is On.
Line: Select Line when you have a standard balanced line input. The phantom voltage and
pre-amplification is Off.
Example:
Audio Input Microphone 1 Type: Line
D15105.05 SX80 Administrator Guide TC7.3, OCTOBER 2015.
Introduction Web interface System settings System settings
Audio Output HDMI [1..2] Level
Define the output level of the HDMI output connector, in steps of 1 dB.
Requires user role: ADMIN
Value space: <-24..0>
Range: Select a value between -24 and 0, in steps of 1 dB.
Example:
Audio Output HDMI 1 Level: 0
Audio Output HDMI [1..2] Mode
Determine if the audio channel on the HDMI output connector shall be enabled.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the audio channel on the HDMI output.
On: Enable the audio channel on the HDMI output.
Example:
Audio Output HDMI 1 Mode: On
Audio Output Line [1..6] Channel
Define whether the Audio Line output is a mono signal or part of a multichannel signal.
Requires user role: ADMIN
Value space: <Right/Left/Mono>
Right: The Audio Line output signal is the right channel of a stereo signal.
Left: The Audio Line output signal is the left channel of a stereo signal.
Mono: The Audio Line output signal is a mono signal.
Example:
Audio Output Line 1 Channel: left
Audio Output Line [1..6] Equalizer ID
Select the audio output line equalizer ID.
Requires user role: ADMIN
Value space: <1..8>
Range: Select EqualizerID 1 to 8.
Example:
Audio Output Line 1 Equalizer ID: 1
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
64
Administrator Guide
Setting passwords Appendices