Systemunit Settings - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80
Contents

SystemUnit settings

SystemUnit Name
Define the system name. The system name will be sent as the hostname in a DHCP request and
when the codec is acting as an SNMP Agent.Define the system name. The system name will be
sent as the hostname in a DHCP request and when the codec is acting as an SNMP Agent.
Requires user role: ADMIN
Value space: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example:
SystemUnit Name: "Meeting Room"
SystemUnit MenuLanguage
This has been replaced with the UserInterface Language setting.
SystemUnit CallLogging Mode
Set the call logging mode for calls that are received or placed by the system. The call logs may
then be viewed via the web interface or using the xCommand CallHistory Get command.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable logging.
On: Enable logging.
Example:
SystemUnit CallLogging Mode: On
D15105.05 SX80 Administrator Guide TC7.3, OCTOBER 2015.
Introduction Web interface System settings System settings
SystemUnit ContactInfo Type
Choose which type of contact information to show in the status field in the upper left corner
of the main display and Touch controller. The information can also be read with the command
xStatus SystemUnit ContactInfo.
Requires user role: ADMIN
Value space: <Auto/None/IPv4/IPv6/H323Id/E164Alias/H320Number/SipUri/SystemName/
DisplayName>
Auto: Show the address which another system can dial to reach this system. The address
depends on the default call protocol and system registration.
None: Do not show any contact information in the status field.
IPv4: Show the IPv4 address as contact information.
IPv6: Show the IPv6 address as contact information.
H323Id: Show the H.323 ID as contact information (see the H323 Profile [1..1] H323Alias ID
setting).
E164Alias: Show the H.323 E164 Alias as contact information (see the H323 Profile [1..1]
H323Alias E164 setting).
H320Number: Show the H.320 number as contact information (only applicable if connected
to a Cisco TelePresence ISDN Link gateway).
SipUri: Show the SIP URI as contact information (see the SIP Profile [1..1] URI setting).
SystemName: Show the system name as contact information (see the SystemUnit Name
setting).
DisplayName: Show the display name as contact information (see the SIP Profile [1..1]
DisplayName setting).
Example:
SystemUnit ContactInfo Type: Auto
SystemUnit IrSensor
Not applicable in this version.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
108
Administrator Guide
Setting passwords Appendices