Cisco TelePresence SX80 Administrator's Manual page 135

Cisco TelePresence SX80
Contents
Setting up the Snap to Whiteboard feature Setting up the Snap to Whiteboard feature
Switch the Snap to Whiteboard feature on or off
1. Tap the contact information in the upper left corner of
the Touch 10 and open the Settings
Administrator.
2. Log in with administrator credentials to open the
Administrator Settings menu.
3. Tap Tracking.
4. When Snap to Whiteboard is set to ON the camera will
capture both the presenter and the whiteboard when the
person talking is close to the whiteboard. Choose OFF if
you want only the person to be captured.
Alternatively, use the Cameras SpeakerTrack Whiteboard
Mode setting in the web interface to switch the Snap to
Whiteboard feature on or off.
D15105.05 SX80 Administrator Guide TC7.3, OCTOBER 2015.
Introduction Web interface
(page 3 of 3)
Note that the Snap to Whiteboard feature only can be used
menu. Then tap when speaker tracking is switched on.
System settings
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
135
Administrator Guide
Setting passwords Appendices Appendices