Cisco TelePresence SX80 Administrator's Manual page 137

Cisco TelePresence SX80
Contents
Briefing room set-up
(page 2 of 3)
Connecting cables
It is very important to connect the cameras and
monitors to the codec as illustrated; otherwise the
configuration that is pushed to the codec when
selecting the Room Types > Briefing
your actual set-up.
Network Microphones,
(LAN) max 8
Audience camera
D15105.05 SX80 Administrator Guide TC7.3, OCTOBER 2015.
Introduction Web interface
About the network ports
SX80 has three network ports. Network port 1 is reserved for
the connection to LAN, while Network ports 2 and 3 should
will not match
be used for the cameras and the Touch 10 user interface.
Loudspeakers,
Computer mono or stereo
1
Presenter camera
Touch 10
user interface
2
System settings
Remote audience
display
Presentation display
Remote presenter display
137
Setting passwords
Remote
Presentation presenter
display display
If the Audience camera unit is a single camera, you
1
should use camera input 1 for the Audience camera and
Power
camera input 3 for the Presenter camera.
If the Ethernet switch does not provide Power over
2
Ethernet (PoE), you need a mid-span PoE injector for
Touch 10. Refer to the
interface appendix for more information.
The Ethernet switch may be connected to either
3
Network port 2 as illustrated, or to Network port 3. It
cannot be connected to Network port 1.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices Appendices
Audience camera
Remote audience display
Presenter camera
Microphones
► Connecting the Touch 10 user