Connecting - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80
Contents
Connecting the Touch 10 user interface
Connecting Touch 10 to the codec via LAN
Connect Touch 10 and the codec to the network wall socket
or network switch as illustrated.
Touch 10 set-up
Once Touch 10 is connected to power, the set-up procedure
begins. Follow the instructions on screen.
When the Select codec to pair with dialog appears, note the
following:
• A list of codecs signalling that they are available for paring
will show up in the dialog. Tap the name of the codec you
want to pair to followed by Start Pairing.
The following is required for the codec to appear in the
list:
• Codec and Touch 10 on the same subnet.
• Codec restarted recently (because the codec
advertises that it is available for pairing only for a
short period of time after it is switched on, refer to the
NetworkServices.> UPnP settings).
• If your codec does not appear in the list of available
codecs, you can pair the devices manually. Click
codec manually..., enter the IP address or host name of
the codec, and tap Start Pairing.
• You have to enter the codec's administrator username
and password for the paring to commence.
If Touch 10 needs software upgrade, new software will
be downloaded from the codec and installed on the unit
automatically as part of the set-up procedure. Touch 10
restarts after the upgrade.
You can verify that Touch 10 is successfully connected to the
codec by checking that the codec address is displayed in the
top banner.
D15105.05 SX80 Administrator Guide TC7.3, OCTOBER 2015.
Introduction Web interface
(page 2 of 3)
Select
Power
• 100-240 VAC
• 50/60 Hz
System settings
SWITCH
PoE
injector
AP
Codec address
The Ethernet connector
is behind the lid at the
rear of Touch 10.
130
Administrator Guide
Setting passwords
Standard
Ethernet cable
Standard
Ethernet cable
PoE rated
Ethernet cable
If the network infrastructure provides
1
Power over Ethernet (PoE), you do
not need a PoE injector; Touch 10
should be connected directly to the
wall socket (Ethernet switch) with a
PoE rated Ethernet cable.
For safety, the PoE source must be
in the same building as Touch 10.
The PoE rated Ethernet cable can be
up to 100 m (330 ft).
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Appendices Appendices
Network (LAN)
Network (LAN)
1