Banner SureCross DX80 Gateway Pro Reference Manual page 31

SureCross™ DX80 Web Configurator
Instruction Manual
Tip
Selecting None for the rule's
remote type negates any rule,
though it continues to appear in
the list until it is deleted.
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Selecting None for remote type negates the rule even though it continues to appear in the list until
deleted. Unused rules at the end of the list always show None as the remote type. To prevent these
from displaying, reduce the number of maps enabled.
Remote Unit # (Slave ID): The Remote Unit number is the slave ID of the remote unit to be read.
The value in this register is then written to the local register listed.
Scale: The raw data in the remote register is multiplied by the scale factor to produce the data
appearing in the floating point register associated with the I/O point.
Swapped: Check the Swapped box to swap the byte orientation.
Other Commands
Prev and Next buttons: Scrolls through the maps/rules.
Update button: Sends new data or settings to the Ethernet Bridge or Gateway Pro.
Network Tab
P/N 134421
1