Housing (Ms 201); Stop Buffer On Handle Housing (Ms - Stihl MS 201 Manual

Installing
1
: Screw the AV spring (2) with
bearing plug (1) onto the
handlebar (arrow) as far as stop.
1
: Push the handlebar (1) into its
seat (arrow).
1
: Insert and tighten down the
screw (1) firmly.
72
2
2
: Push the bearing plug (1) into its
seat (arrow) on the underside of
the machine.
: Coat the screw (2) with Loctite, fit
it and tighten it down firmly, b 14
– Install the switch shaft and
handle molding, b 10.3
9.4 Stop Buffer on Handle

Housing (MS 201)

– Disengage the chain brake and
remove the chain sprocket cover,
bar and chain.
– Remove the clutch drum, b 4.2
2
3
: Take out the screws (1).
: Remove covers (2) and (3).
1
1
1
1
MS 201, MS 201 C, MS 201 T, MS 201 TC
1
: Pry out and replace the stop
buffer (1).
Installing
1
– Coat taper of stop buffer with
STIHL press fluid, b 14
: Position the stop buffer (1) so
that its taper points in the
direction of the handle housing.
: Press the stop buffer (1) in the
hole (arrow) and make sure it is
properly seated.
– Reassemble all other parts in the
reverse sequence.