Displaying Snmp Status - Cisco Catalyst 2928 Software Configuration Manual

Chapter 29 Configuring SNMP
This example shows how to send Entity MIB traps to the host cisco.com. The community string is
restricted. The first line enables the switch to send Entity MIB traps in addition to any traps previously
enabled. The second line specifies the destination of these traps and overwrites any previous
snmp-server host commands for the host cisco.com.
Switch(config)# snmp-server enable traps entity
Switch(config)# snmp-server host cisco.com restricted entity
This example shows how to enable the switch to send all traps to the host myhost.cisco.com using the
community string public:
Switch(config)# snmp-server enable traps
Switch(config)# snmp-server host myhost.cisco.com public
This example shows how to associate a user with a remote host and to send auth (authNoPriv)
authentication-level informs when the user enters global configuration mode:
Switch(config)# snmp-server engineID remote 192.180.1.27 00000063000100a1c0b4011b
Switch(config)# snmp-server group authgroup v3 auth
Switch(config)# snmp-server user authuser authgroup remote 192.180.1.27 v3 auth md5
mypassword
Switch(config)# snmp-server user authuser authgroup v3 auth md5 mypassword
Switch(config)# snmp-server host 192.180.1.27 informs version 3 auth authuser config
Switch(config)# snmp-server enable traps
Switch(config)# snmp-server inform retries 0

Displaying SNMP Status

To display SNMP input and output statistics, including the number of illegal community string entries,
errors, and requested variables, use the show snmp privileged EXEC command. You also can use the
other privileged EXEC commands in
the fields in the displays, see the Cisco IOS Configuration Fundamentals Command Reference, Release
12.2.
Table 29-6
Feature
show snmp
show snmp engineID [local | remote]
show snmp group
show snmp pending
show snmp sessions
show snmp user
OL-23389-01
Table 29-6
Commands for Displaying SNMP Information
Default Setting
Displays SNMP statistics.
Displays information on the local SNMP engine and all
remote engines that have been configured on the device.
Displays information on each SNMP group on the network.
Displays information on pending SNMP requests.
Displays information on the current SNMP sessions.
Displays information on each SNMP user name in the
SNMP users table.
Note
to display SNMP information. For information about
You must use this command to display SNMPv3
configuration information for auth | noauth | priv
mode. This information is not displayed in the show
running-config output.
Catalyst 2928 Switch Software Configuration Guide
Displaying SNMP Status
29-17