Cisco Catalyst 2928 Software Configuration Manual page 41

Chapter 1 Overview
DHCP client is enabled, the DHCP server is enabled (only if the device acting as a DHCP server is
•
configured and is enabled), and the DHCP relay agent is enabled (only if the device is acting as a
DHCP relay agent is configured and is enabled). For more information, see
the Switch IP Address and Default Gateway,"
Source Guard Features."
Switch cluster is disabled. For more information about switch clusters, see
•
Switches."
No passwords are defined. For more information, see
•
System name and prompt is Switch. For more information, see
•
Switch."
NTP is enabled. For more information, see
•
DNS is enabled. For more information, see
•
TACACS+ is disabled. For more information, see
•
Authentication."
RADIUS is disabled. For more information, see
•
Authentication."
The standard HTTP server and Secure Socket Layer (SSL) HTTPS server are both enabled. For more
•
information, see
IEEE 802.1x is disabled. For more information, see
•
Port-Based Authentication."
• Port parameters
–
–
–
–
No Smartports macros are defined. For more information, see the Auto Smartports Configuration
•
Guide.
VLANs
•
–
–
–
–
–
–
• STP, PVST+ is enabled on VLAN 1. For more information, see
MSTP is disabled. For more information, see
•
Optional spanning-tree features are disabled. For more information, see
•
Optional Spanning-Tree Features."
OL-23389-01
Chapter 8, "Configuring Switch-Based Authentication."
Interface speed and duplex mode is autonegotiate. For more information, see
"Configuring Interface Characteristics."
Auto-MDIX is enabled. For more information, see
Characteristics."
Flow control is off. For more information, see
PoE is autonegotiate. For more information, see
Characteristics."
Default VLAN is VLAN 1. For more information, see
VLAN trunking setting is dynamic auto (DTP). For more information, see
"Configuring VLANs."
Trunk encapsulation is negotiate. For more information, see
VTP mode is server. For more information, see
VTP version is Version 1. For more information, see
Voice VLAN is disabled. For more information, see
Default Settings After Initial Switch Configuration
and Chapter 20, "Configuring DHCP Features and IP
Chapter 7, "Administering the Switch."
Chapter 7, "Administering the
Chapter 7, "Administering the Switch."
Chapter 7, "Administering the Switch."
Chapter 8, "Configuring Switch-Based
Chapter 8, "Configuring Switch-Based
Chapter 9, "Configuring IEEE 802.1x
Chapter 12, "Configuring Interface
Chapter 12, "Configuring Interface
Chapter 13, "Configuring VLANs."
Chapter 13, "Configuring VLANs."
Chapter 14, "Configuring VTP."
Chapter 14, "Configuring VTP."
Chapter 15, "Configuring Voice VLAN."
Chapter 16, "Configuring STP."
Chapter 17, "Configuring MSTP."
Catalyst 2928 Switch Software Configuration Guide
Chapter 3, "Assigning
Chapter 5, "Clustering
Chapter 12,
Chapter 13,
Chapter 18, "Configuring
1-9