Cisco Catalyst 2928 Software Configuration Manual page 635

Appendix B Working with the Cisco IOS File System, Configuration Files, and Software Images
Downloading the Configuration File By Using TFTP
To configure the switch by using a configuration file downloaded from a TFTP server, follow these steps:
Step 1 Copy the configuration file to the appropriate TFTP directory on the workstation.
Verify that the TFTP server is properly configured by referring to the
Step 2
a Configuration File By Using TFTP" section on page
Step 3 Log into the switch through the console port or a Telnet session.
Download the configuration file from the TFTP server to configure the switch.
Step 4
Specify the IP address or hostname of the TFTP server and the name of the file to download.
Use one of these privileged EXEC commands:
•
•
The configuration file downloads, and the commands are executed as the file is parsed line-by-line.
This example shows how to configure the software from the file tokyo-confg at IP address 172.16.2.155:
Switch# copy tftp://172.16.2.155/tokyo-confg system:running-config
Configure using tokyo-confg from 172.16.2.155? [confirm] y
Booting tokyo-confg from 172.16.2.155:!!! [OK - 874/16000 bytes]
Uploading the Configuration File By Using TFTP
To upload a configuration file from a switch to a TFTP server for storage, follow these steps:
Verify that the TFTP server is properly configured by referring to the
Step 1
a Configuration File By Using TFTP" section on page
Log into the switch through the console port or a Telnet session.
Step 2
Upload the switch configuration to the TFTP server. Specify the IP address or hostname of the TFTP
Step 3
server and the destination filename.
Use one of these privileged EXEC commands:
•
•
The file is uploaded to the TFTP server.
This example shows how to upload a configuration file from a switch to a TFTP server:
Switch# copy system:running-config tftp://172.16.2.155/tokyo-confg
Write file tokyo-confg on host 172.16.2.155? [confirm] y
#
Writing tokyo-confg!!! [OK]
OL-23389-01
copy tftp:[[[//location]/directory]/filename] system:running-config
copy tftp:[[[//location]/directory]/filename] nvram:startup-config
copy system:running-config tftp:[[[//location]/directory]/filename]
copy nvram:startup-config tftp:[[[//location]/directory]/filename]
Working with Configuration Files
"Preparing to Download or Upload
B-10.
"Preparing to Download or Upload
B-10.
Catalyst 2928 Switch Software Configuration Guide
B-11