Cisco Catalyst 2928 Software Configuration Manual page 58

Accessing the CLI
For information about configuring the switch for Telnet access, see the
for a Terminal Line" section on page
Changes made by one Telnet user are reflected in all other Telnet sessions.
For information about configuring the switch for SSH, see the
Shell" section on page
After you connect through the console port, through a Telnet session or through an SSH session, the
user EXEC prompt appears on the management station.
Catalyst 2928 Switch Software Configuration Guide
2-10
8-6. The switch supports up to 16 simultaneous Telnet sessions.
8-33. The switch supports up to five simultaneous secure SSH sessions.
Chapter 2 Using the Command-Line Interface
"Setting a Telnet Password
"Configuring the Switch for Secure
OL-23389-01