Cisco Catalyst 2928 Software Configuration Manual page 385

Chapter 19 Configuring DHCP Features and IP Source Guard Features
The DHCP server receives the packet. If the server is option-82-capable, it can use the remote ID,
•
the circuit ID, or both to assign IP addresses and implement policies, such as restricting the number
of IP addresses that can be assigned to a single remote ID or circuit ID. Then the DHCP server
echoes the option-82 field in the DHCP reply.
The DHCP server unicasts the reply to the switch if the request was relayed to the server by the
•
switch. The switch verifies that it originally inserted the option-82 data by inspecting the remote ID
and possibly the circuit ID fields. The switch removes the option-82 field and forwards the packet
to the switch port that connects to the DHCP client that sent the DHCP request.
When the described sequence of events occurs, the values in these fields in
Circuit-ID suboption fields
•
–
–
–
–
Remote-ID suboption fields
•
–
–
–
–
In the port field of the circuit-ID suboption, the port numbers start at 1. For example, on a switch with
24 10/100 ports and small form-factor pluggable (SFP) module slots, port 1 is the Fast Ethernet 0/1 port,
port 2 is the Fast Ethernet 0/2 port, and so forth, and the Gigabit Ethernet interface 0/1 is port 25.
On a switch with 48 ports, Gigabit Etnernet interface 0/1 is port 49.
Figure 19-2
switch uses the packet formats when you globally enable DHCP snooping and enter the ip dhcp
snooping information option global configuration command.
OL-23389-01
Suboption type
Length of the suboption type
Circuit-ID type
Length of the circuit-ID type
Suboption type
Length of the suboption type
Remote-ID type
Length of the remote-ID type
shows the packet formats for the remote-ID suboption and the circuit-ID suboption. The
Understanding DHCP Snooping
Figure 19-2
Catalyst 2928 Switch Software Configuration Guide
do not change:
19-5