Table - Cisco Catalyst 2928 Software Configuration Manual

Configuring IEEE 802.1x Authentication

Table 9-2

Feature
Number of seconds between
re-authentication attempts
Re-authentication number
Quiet period
Retransmission time
Maximum retransmission number
Client timeout period
Authentication server timeout period
Guest VLAN
Authenticator (switch) mode
MAC authentication bypass
Beginning with Cisco IOS Release 12.2(55)SE, you can filter out verbose system messages generated
by the authentication manager. The filtered content typically relates to authentication success. You can
also filter verbose messages for 802.1x authentication and MAB authentication. There is a separate
command for each authentication method:
The no authentication logging verbose global configuration command filters verbose messages
•
from the authentication manager.
The no dot1x logging verbose global configuration command filters 802.1x authentication verbose
•
messages.
The no mab logging verbose global configuration command filters MAC authentication bypass
•
(MAB) verbose messages
For more information, see the command reference for this release.
Catalyst 2928 Switch Software Configuration Guide
9-18
Default IEEE 802.1x Authentication Configuration (continued)
Chapter 9 Configuring IEEE 802.1x Port-Based Authentication
Default Setting
3600 seconds.
2 times (number of times that the switch restarts the
authentication process before the port changes to the
unauthorized state).
60 seconds (number of seconds that the switch remains in
the quiet state following a failed authentication exchange
with the client).
30 seconds (number of seconds that the switch should
wait for a response to an EAP request/identity frame
from the client before resending the request).
2 times (number of times that the switch will send an
EAP-request/identity frame before restarting the
authentication process).
30 seconds (when relaying a request from the
authentication server to the client, the amount of time the
switch waits for a response before resending the request
to the client.)
30 seconds (when relaying a response from the client to
the authentication server, the amount of time the switch
waits for a reply before resending the response to the
server. This setting is not configurable.)
None specified.
None specified.
Disabled.
OL-23389-01