Table of Contents
Advertisement
Chapter 17
Configuring MSTP
Beginning in privileged EXEC mode, follow these steps to configure a switch as the secondary root
switch. This procedure is optional.
Command
Step 1
configure terminal
Step 2
spanning-tree mst instance-id root
secondary [diameter net-diameter
[hello-time seconds]]
Step 3
end
Step 4
show spanning-tree mst instance-id
Step 5
copy running-config startup-config
To return the switch to its default setting, use the no spanning-tree mst instance-id root global
configuration command.
Configuring Port Priority
If a loop occurs, the MSTP uses the port priority when selecting an interface to put into the forwarding
state. You can assign higher priority values (lower numerical values) to interfaces that you want selected
first and lower priority values (higher numerical values) that you want selected last. If all interfaces have
the same priority value, the MSTP puts the interface with the lowest interface number in the forwarding
state and blocks the other interfaces.
Beginning in privileged EXEC mode, follow these steps to configure the MSTP port priority of an
interface. This procedure is optional.
Command
Step 1
configure terminal
Step 2
interface interface-id
OL-23389-01
Purpose
Enter global configuration mode.
Configure a switch as the secondary root switch.
•
For instance-id, you can specify a single instance, a range of
instances separated by a hyphen, or a series of instances
separated by a comma. The range is 0 to 4094.
(Optional) For diameter net-diameter, specify the maximum
•
number of switches between any two end stations. The range is 2
to 7. This keyword is available only for MST instance 0.
(Optional) For hello-time seconds, specify the interval in
•
seconds between the generation of configuration messages by
the root switch. The range is 1 to 10 seconds; the default
is 2 seconds.
Use the same network diameter and hello-time values that you used
when configuring the primary root switch. See the
Root Switch" section on page
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify an interface to configure, and enter interface
configuration mode.
Valid interfaces include physical ports and port-channel
logical interfaces. The port-channel range is 1 to 6.
Catalyst 2928 Switch Software Configuration Guide
Configuring MSTP Features
"Configuring the
17-17.
17-19
Advertisement
Table of Contents
Troubleshooting
