Default Snmp Configuration - Cisco Catalyst 2928 Software Configuration Manual

Configuring SNMP
Table 29-3
Interface Type
Tunnel
Physical (such as Gigabit Ethernet or SFP
Null
1. SVI = switch virtual interface
2. SFP = small form-factor pluggable
The switch might not use sequential values within a range.
Note
Configuring SNMP
•
•
•
•
•
•
•
•
•

Default SNMP Configuration

Table 29-4
Table 29-4
Feature
SNMP agent
SNMP trap receiver
SNMP traps
SNMP version
SNMPv3 authentication
SNMP notification type
1. This is the default when the switch starts and the startup configuration does not have any snmp-server global configuration
Catalyst 2928 Switch Software Configuration Guide
29-6
ifIndex Values
Default SNMP Configuration, page 29-6
SNMP Configuration Guidelines, page 29-7
Disabling the SNMP Agent, page 29-7
Configuring Community Strings, page 29-8
Configuring SNMP Groups and Users, page 29-9
Configuring SNMP Notifications, page 29-11
Setting the Agent Contact and Location Information, page 29-15
Limiting TFTP Servers Used Through SNMP, page 29-15
SNMP Examples, page 29-16
shows the default SNMP configuration.
Default SNMP Configuration
commands.
2
-module interfaces)
Default Setting
1
Disabled .
None configured.
None enabled except the trap for TCP connections (tty).
If no version keyword is present, the default is Version 1.
If no keyword is entered, the default is the noauth (noAuthNoPriv)
security level.
If no type is specified, all notifications are sent.
Chapter 29 Configuring SNMP
ifIndex Range
5078–5142
10000–14500
14501
OL-23389-01