Cisco Catalyst 2928 Software Configuration Manual page 602

Ios release 12.2(55)ez
Table of Contents

Advertisement

Recovering from a Command Switch Failure
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]:
Enter Y at the first prompt.
Step 6
The prompts in the setup program vary depending on the switch you selected to be the command switch:
Continue with configuration dialog? [yes/no]: y
or
Configuring global parameters:
If this prompt does not appear, enter enable, and press Return. Enter setup, and press Return to start
the setup program.
Respond to the questions in the setup program.
Step 7
When prompted for the hostname, recall that on a command switch, the hostname is limited to 28
characters. Do not use -n, where n is a number, as the last character in a hostname for any switch.
When prompted for the Telnet (virtual terminal) password, recall that it can be from 1 to 25 alphanumeric
characters, is case sensitive, allows spaces, but ignores leading spaces.
When prompted for the enable secret and enable passwords, enter the passwords of the failed command
Step 8
switch again.
When prompted, make sure to enable the switch as the cluster command switch, and press Return.
Step 9
When prompted, assign a name to the cluster, and press Return.
Step 10
The cluster name can be 1 to 31 alphanumeric characters, dashes, or underscores.
When the initial configuration displays, verify that the addresses are correct.
Step 11
If the displayed information is correct, enter Y, and press Return.
Step 12
If this information is not correct, enter N, press Return, and begin again at Step 9.
Start your browser, and enter the IP address of the new command switch.
Step 13
From the Cluster menu, select Add to Cluster to display a list of candidate switches to add to the cluster.
Step 14
Catalyst 2928 Switch Software Configuration Guide
33-10
Chapter 33
Troubleshooting
OL-23389-01

Advertisement

Table of Contents
loading

Table of Contents