Common Session Id - Cisco Catalyst 2928 Software Configuration Manual

Understanding IEEE 802.1x Port-Based Authentication
Users who fail authentication remain in the restricted VLAN until the next re-authentication attempt. A
port in the restricted VLAN tries to re-authenticate at configured intervals (the default is 60 seconds). If
re-authentication fails, the port remains in the restricted VLAN. If re-authentication is successful, the
port moves either to the configured VLAN or to a VLAN sent by the RADIUS server. You can disable
re-authentication. If you do this, the only way to restart the authentication process is for the port to
receive a link down or EAP logoff event. We recommend that you keep re-authentication enabled if a
client might connect through a hub. When a client disconnects from the hub, the port might not receive
the link down or EAP logoff event.
After a port moves to the restricted VLAN, a simulated EAP success message is sent to the client. This
prevents clients from indefinitely attempting authentication. Some clients (for example, devices running
Windows XP) cannot implement DHCP without EAP success.
Restricted VLANs are supported only on 802.1x ports in single-host mode and on Layer 2 ports.
You can configure any active VLAN except an RSPAN VLAN or a voice VLAN as an 802.1x restricted
VLAN. The restricted VLAN feature is not supported on trunk ports; it is supported only on access ports.
This feature works with port security. As soon as the port is authorized, a MAC address is provided to
port security. If port security does not permit the MAC address or if the maximum secure address count
is reached, the port becomes unauthorized and error disabled.
Other port security features such as dynamic ARP Inspection, DHCP snooping, and IP source guard can
be configured independently on a restricted VLAN.
For more information, see the

Common Session ID

Authentication manager uses a single session ID (referred to as a common session ID) for a client no
matter which authentication method is used. This ID is used for all reporting purposes, such as the show
commands and MIBs. The session ID appears with all per-session syslog messages.
The session ID includes:
•
•
•
This example shows how the session ID appears in the output of the show authentication command. The
session ID in this example is 160000050000000B288508E5:
Switch# show authentication sessions
Interface
Fa4/0/4
This is an example of how the session ID appears in the syslog output. The session ID in this example
is also160000050000000B288508E5:
1w0d: %AUTHMGR-5-START: Starting 'mab' for client (0000.0000.0203) on Interface Fa4/0/4
AuditSessionID 160000050000000B288508E5
1w0d: %MAB-5-SUCCESS: Authentication successful for client (0000.0000.0203) on Interface
Fa4/0/4 AuditSessionID 160000050000000B288508E5
1w0d: %AUTHMGR-7-RESULT: Authentication result 'success' from 'mab' for client
(0000.0000.0203) on Interface Fa4/0/4 AuditSessionID 160000050000000B288508E5
The session ID is used by the NAD, the AAA server, and other report-analyzing applications to identify
the client. The ID appears automatically. No configuration is required.
Catalyst 2928 Switch Software Configuration Guide
9-16
The IP address of the Network Access Device (NAD)
A monotonically increasing unique 32 bit integer
The session start time stamp (a 32 bit integer)
MAC Address
0000.0000.0203
Chapter 9
"Configuring MAC Authentication Bypass" section on page
Method Domain Status
mab DATA Authz Success
Configuring IEEE 802.1x Port-Based Authentication
Session ID
160000050000000B288508E5
9-31.
OL-23389-01