Changing Target Values - Laversab 6300 User Manual

6300 Rev H User's Manual
Figure 3.6 : Select inHg
3.4

CHANGING TARGET VALUES

Note: Target values are maintained through a power OFF/ON cycle.
Pitot Target value
The Pitot Target value can be changed only if the key# symbol (2) is displayed to the left of the Pitot
Target value field. Press key '2' on the keypad and the Lower section of the display will appear as shown
in Figure 3.7 below.
Figure 3.7 : Pitot Target value
Use the keypad to enter the desired value in the field shown. To clear an entry, press CLR. To accept the
entry, press ENTER. To exit this screen without changing the Target value, press CANC. If the number
of digits entered (either before or after the decimal) exceeds the maximum allowed for the current units, a
long beep will be heard.
If the entered value exceeds the programmed limits, the following message will appear.
Pitot target exceeds limit. Press CLR
If the Target value needs to be changed in small increments, instead of entering a value, the arrow keys
may be used to Jog the Target value up or down. If the current Pitot Target value is 20.0 knots, and the
125-9106A Page 24