Target Value Entry - Laversab 6300-M3 User Manual

3.2.2 TARGET VALUE ENTRY

Note: Target values are maintained through a power OFF/ON cycle.
Pitot target value : A Pt or airspeed target value can be entered using the Pt/AIRSPEED key.
On pressing this key the target value field for Pt gets put into reverse video. The 6300-M3 is
now awaiting numeric entry from the operator. While this new value is being entered, the old
target value is still effective and does not in any way affect the Pitot output. After the
Pt/AIRSPEED key is pressed, the display will appear as shown below.
Units:
Actual:
Target:
Use the numeric keys to enter the value. Use the +/- key to change the sign of the value. The
6300-M3 will beep on every key entry, and it will beep for a longer time period if extra invalid
digits are entered. It is not necessary to enter the decimal point and the digit after the decimal
point if that digit is "0". That is, if you want to enter the number "200.0" you may enter just
"200" and leave out the "." And the "0". After entering "200" the display will appear as
shown below.
Units:
Actual:
Target:
If a mistake is made during entry, it can only be corrected by using the CLR key to clear the
entry and re-entering the value. When the desired value is input into the value entry field,
press ENTER and the value will blink. The trailing decimal and '0' will automatically get
added. In the sample screen below the "200.0" is shown shadowed to indicate "blinking".
Units:
Actual:
Target:
knots
M 101.2
knots
M 101.2
200
knots
M 101.2
200.0
20
Feet/min Feet
3500 1005
3000
Feet/min Feet
3500 1005
3000
Feet/min Feet
3500 1005
3000
M
0
M
0
M
0