Table of Contents
Advertisement
6300 Rev H User's Manual
This section provides all the details required to operate the 6300. It is highly recommended that the user
read through this section before operating the 6300. After understanding these details, the user should
refer to the 'Typical Use' chart shown in Figure 5.1, which outlines a step-by-step process of using the
6300 with an aircraft.
3.1
START-UP
Open the Pitot and Static ports to ambient by removing the blue caps.
•
Connect the Remote unit to the Main unit using the Remote cable.
•
Connect AC power to the Main unit using the power cable.
•
Turn On the AC On/Off switch on the Top Panel of the Main unit.
•
Wait for the Ready LED to turn On.
•
Press the Power key on the Remote for about 4 seconds until the display turns On.
•
Release the Power key. After the sign-on screen, the display will appear similar to that shown in
•
Figure 3.1 (next page).
Note: The pumps will be Off. The pumps turn On only if one of the outputs is in either Control or
Leak mode. The pumps also turn On during Self-Test.
Perform a Self-Test by pressing the
•
GO. Press
CANC
ports are open to ambient, then press GO.
The Self-Test takes about 2 minutes. When it is completed, the message 'Self-Test successful. Press
•
CANC
to exit' will appear on the last line. Press CANC.
The following sub-section provides details of the parameters shown on the main operating screen and
how to modify these parameters.
Later sub-sections provide details on how to perform various other functions of the 6300
125-9106A
SECTION 3 : OPERATING THE 6300
TEST
key. The message 'Open both ports to ambient, then press
to exit' will be displayed in the Lower section of the display. Make sure both
Page 15
Advertisement
Table of Contents
