Laversab 6300 User Manual page 23

6300 Rev H User's Manual
Figure 3.4 : Select QcinHg
Static units
Static units can be changed only if the key# symbol (5) is displayed to the right of the Static units field.
Press key '5' on the keypad and the Lower section of the display will appear as shown in Figure 3.5
below.
Figure 3.5 : Select Static units
The 7 Static units are shown on this screen. Press the key with the # (shown in blue) associated with the
unit to be selected. For example, if units of inHg is to be selected, in the 'Static units' screen, press '3'.
The Lower section will blank out and the Upper section will appear as shown in Figure 3.6 below.
The fields for Static units, Static target and Static-Rate target will be blinking. The Actual and Target
values will be based on the selected unit. To activate units of inHg, press GO. To revert back to the
original units, press CANC.
If Target values (or any other Pitot or Static parameters) need to be changed, they can be changed before
pressing GO. When GO is pressed, the blinking stops and units of inHg becomes activated.
125-9106A Page 23