Laversab 6300 User Manual page 26

6300 Rev H User's Manual
Static Target value
The Static Target value can be changed only if the key# symbol
Target value field. Press key '6' on the keypad and the Lower section of the display will appear as shown
in Figure 3.9 below.
Use the keypad to enter the desired value in the field shown. To clear an entry, press CLR. To accept the
entry, press ENTER. To exit this screen without changing the Target value, press CANC. If the number
of digits entered (either before or after the decimal) exceeds the maximum allowed for the current units, a
long beep will be heard.
If the entered value exceeds the programmed limits, the following message will appear.
If the Target value needs to be changed in small increments, instead of entering a value, the arrow keys
may be used to Jog the Target value up or down. If the current Static Target value is 0 Feet, and the
Lower screen appears as in Figure 3.9 above, pressing the
shown in Figure 3.10 below.
125-9106A
Qc mmHg
Pt kpa
Qc kpa
EPR
Figure 3.9 : Static Target value
Static target exceeds limit. Press
0.01
0.001
0.001
0.001
(6) is displayed to the right of the Static
CLR
Up-Arrow key will make the screen appear as
Page 26