Understanding The 6300-M3; Start Up - Laversab 6300-M3 User Manual

Hide thumbs

Table Of Contents

Table of Contents

Note: Pt = Pitot and Ps= Static

The 6300-M3 is typically used to calibrate and check air data instruments like altimeters, climb

indicators, and airspeed/ Mach indicators on an aircraft. It is also used to leak-check the

Pitot/ Static system of an aircraft. This section will explain how to use the 6300-M3 to perform

these functions.

3.1

START UP

Step 1:

Connect the Remote cable to the Remote unit and the "Remote" connector on the

main unit.

Step 2:

Check the ON/OFF switch on the Remote unit and make sure it is OFF.

Step 3:

Remove the protective caps from one each of the Pitot and Static outputs on the

main unit. DO NOT connect any hoses yet. Make certain that the outputs are

open to ambient. Close Pitot and Static Vent valves.

Step 4:

Connect the power cable to the "AC INPUT" connector on the main unit and

connect the far end of the power cable to an AC supply.

Step 5:

On the Main unit, turn the AC On/Off switch ON. On the Remote unit, turn the

ON/OFF switch ON.

The 6300-M3 will turn ON and the Remote unit will turn ON. The display will briefly show

the sign-on screen and then go into the Main screen. The Main screen should appear as

follows:

Units:

Actual:

Target:

The Actual values shown on line 2 will be different from the ones shown. The 4th line should

be blank.

Before actually using the 6300-M3 to perform certain tasks, it is important to understand how

to use the Remote unit to make the 6300-M3 do what you want. This section explains

everything about the information that you see on the Remote unit and what it means, and

SECTION 3