Setting Your Meter; Battery Use; Setting Mode - Infopia ELEMENT MULTI Instructions For Use Manual

Setting Your Meter

Battery Use

The Element Multi requires two(2) AAA 1.5 volt alkaline batteries.
When to replace the batteries:
The meter will give you an indication on the display that the batteries need to be
changed. When the battery icon is displayed, please change the batteries to high
quality alkaline batteries. It is recommended to keep a spare set of batteries on
hand. To extend battery life, remove the test strip as soon as a result is displayed.
How to install /replace the batteries:
1. Open the battery cover on the back of the Element Multi.
2. Remove old batteries from the compartment and safely discard.
3. Insert the new batteries into the battery compartment as marked on the
inside compartment.
4.Close the battery cover. To make sure the batteries were installed
correctly, push either one of the two buttons on the front of the meter to turn
the Element Multi on.
<Follow Action>
1. Check your meter with the control solution.
2. Perform your test again.
Caution
Remove both batteries from the battery compartment and dispose of them according to
your institution's guidelines.
• 16 •
Setting Your Meter

Setting Mode

It is recommended to set your Element Multi meter properly before using.
The meter enters setting mode with a beep sound
by pressing the mode (
seconds in the stand-by status. Press Mode (
button for the next step.
By pressing Up( ▲) or Down ( ▼ ) button, adjust
year and press Mode (
By pressing UP( ▲) or Down ( ▼ ) button, adjust
date, month and time, and then press Mode (
button.
Caution
Make sure that the date and time are set properly to enable your data to be stored and
downloaded properly.
) button for 3 or more
) button.
• 17 •
)
)