Setting The Meter - Infopia EasyGluco Operation Manual

Checking the System with the EasyGluco
STEP 3: Result appears in 9 seconds
Once you hear the "beep" , it indicates that the test strip is filled and the meter will begin to count down from "9" seconds to "1" second
and the control solution test result will be displayed (picture 3). Compare the result with the range printed on the Test Strip vial. The
result should fall within that range.
Comparing Control Solution Results
If the control solution test results fall outside the range, repeat the test. Out of range results may be caused by one or more of the
following:
·Error in performing the test.
·Failure to shake the control solution vial well enough (must shake vigorously).
·Failure to discard the first drop of control solution.
·Expired or contaminated control solution.
·Test Strip deterioration.
·Meter malfunction (Use the Check Strip in your EasyGluco
·Control solution that is too warm or cool.
[ 11 ]
EasyGluco
TM
TM Control Solution
TM kit to check the meter).

Setting The Meter

The EasyGluco TM Meter has three functional modes as settings: 1) Average period, 2) Unit, 3) Date & Time.
If you need to change the time, or if you remove the battery, you may need to enter the setting mode and reset.
Turn on the meter by pressing the SET button for 3 seconds. This will initiate the "Set the Meter"mode.
How to Calculate Your Average Blood Glucose Level
Enter set mode Change the status
The setting mode begins with setting the number of days of which you would like to receive an average calculation of your glucose level.
The LCD window will be flashing the most recent number of days that was selected. The number of days can range from 7 days to 90
days. To increase the number of days, press the SET button; holding the SET button down will increase the value at a quicker rate.
With the correct number of days displayed, press the MEM button. This will set the number of days that you would like to receive your
average blood glucose calculation. (By pressing the MEM button it saves your settings as well as moves you to your next item to set).
Move to next
INFOPIA [ 12 ]