Checking The System With Control Solution - Infopia ELEMENT MULTI Instructions For Use Manual

Setting Your Meter
By pressing Up(▲) or Down(▼) button, select average
date and press Mode (
Note : This average date is applied to glucose
By pressing Up(▲) or Down(▼) button, select Alarm
ON/OFF and press Mode (
If you select Alarm ON, you can set the time by pressing
Up(▲) or Down(▼) button, and press Mode (
button(you can set 2 alarms).
By Pressing ▲▼, select print ON/OFF and press
Mode(
button to active it. If you select print, this setting mode is
completed.
By pressing Up(▲) or
Down(▼) button, select testing
unit and press Mode (
button.
By pressing Up(▲) or Down(▼
) button, select temperature
unit and press Mode (
button.
) button.
testing only.
) button.
). If you select 'ON' and press Mode(
• 18 •

Checking the system with control solution

Quality control by control solution
Control testing, also known as quality control testing, is used to ensure all the
parts of the test system are working properly together and the test results are
accurate and reliable within the limits of the system. Contact customer support of
)
local representative.
The users should follow their facility's policies on when controls should be tested
(for example: with each new test strip lot; monthly as a continued check on
storage conditions;whenever issues (storage,operator,or other) are identified or
there are questions about the results).
The control solution should be used
)
• Whenever you suspect the meter or test strip is not functioning properly.
• If your blood glucose test results are not consistent with your symptoms or if
you think they are not accurate.
• If you have dropped the meter
• For quality control at the point of care
• For teaching or learning the system
)
)
Note:
The Element Multi Control Solutions are sold separately.
The TC(Level 1, Level 2), TG(Level 1, Level 2) and HDL (Level 1, Level 2) control
solutions can be obtained.
• 19 •