Epson RC90 Safety And Installation page 9

Before Reading This Manual
TP port of RC90 is for the Teach Pendant TP1 and TP2.

NOTE
the followings to TP port of RC90. Connecting to the followings may result in
malfunction of the device since the pin assignments are different.
OPTIONAL DEVICE dummy plug
Operation Pendant OP500
Operator Pendant OP500RC
Jog Pad JP500
Teaching Pendant TP-3** series
Operator Panel OP1
For RC90, be sure to install the EPSON RC+7.0 to the development PC first,
 NOTE
then connect the development PC and RC90 with the USB cable.
If RC90 and the development PC are connected without installing the EPSON
RC+7.0 to the development PC, [Add New Hardware Wizard] appears. If
this wizard appears, click the <Cancel> button.
Concerning the security support for the network connection:
 NOTE
The network connecting function (Ethernet) on our products assumes the use
in the local network such as the factory LAN network. Do not connect to the
external network such as Internet.
In addition, please take security measure such as for the virus from the
network connection by installing the antivirus software.
Security support for the USB memory:
 NOTE
Make sure the USB memory is not infected with virus when connecting to the
Controller.
Safety and Installation (RC90 / EPSON RC+ 7.0) Rev.6
Do not connect
vii