Room Sensor; Device Data; Wireless; Binding - Siemens Albatros2 RVS46 User Manual

Operation HCP
Action occupancy button

Room sensor

Device data

Binding

Binding
Test mode

Device list wireless

Delete all devices
54/100
Siemens Schweiz AG
HVAC Products
Depending on operating line 40, the action of operation (operating mode button or
setting knob) on room unit 1, on the operator unit or service unit can be defined for
heating circuit P.
Commonly with HC1
Operation acts jointly on heating circuits 1 and 2.
Independently
Operating mode changes or readjustments of the Comfort setpoints are to be made in
programming mode.
The action of the occupancy button on the operator unit can be assigned to the relevant
heating circuits.
If only 1 heating circuit is assigned, the occupancy button always acts on that heating
circuit.
Line no. Operating line
54 Readjustment room sensor
The temperature display can be readjusted.
Line no. Operating line
70 Software version
The display shows the current version of the room unit.

6.3 Wireless

Line no. Operating line
120 Binding
121 Test mode
For more detailed information, refer to the descriptions of the wireless components in
section 3.7.
When commissioning the system, the wireless peripheral devices (room unit) are
assigned to the basic unit.
The test mode is used for checking the wireless communication. The test should be
made when the installation is fully completed.
Line no. Operating line
130 Room unit 1
Missing
Ready
No reception
Change batt
131 Room unit 2
Same as on operating line 130
132 Outside sensor
Same as on operating line 130
133 Repeater
Same as on operating line 130
134 Operator unit
Same as on operating line 130
135 Service unit
Same as on operating line 130
138 Delete all devices
The wireless connection to all devices will be canceled. If radio communication is
required again, a new binding must be established.
User Manual
The settings in detail
CE1U2353en
22. November 2006