Establishing the link
Testing
Dimensions and drilling plan
26/100
Siemens Schweiz AG
HVAC Products
1.
Press the button on the radio module for at least 8
seconds until the LED on the radio module starts
flashing at high frequency.
2.
Press the button on the transmitter of the wireless
outside sensor for at least 8 seconds until that LED
also starts flashing at high frequency.
3.
The link is established when the LED on the radio
module extinguishes.
4.
Press the button on the transmitter of the wireless outside sensor briefly again until
the LED extinguishes.
The test is made to check the quality of the radio link.
•
The test can be stopped by pressing the ESC button
•
While the radio link can be opened on the boiler, the test should be made at the
location where the room unit will be installed
1.
Press button 3 on the transmitter of the wireless outside sensor for a maximum of 8
seconds until the LED starts flashing at low frequency.
2.
When radio communication works, the LED on the radio module flashes briefly at
10-second intervals.
3.
After the test, press the button on the transmitter of the wireless outside sensor
again briefly until the LED extinguishes.
90
4,2
2
1
56
60
User Manual
Mounting and installation
32
Button
79,8
49,7
3
5,5
Ø 14,1
24,5
25
49,5
22. November 2006
LED
CE1U2353en