Building And Room Model; Frost Protection Plant; Sensor State; Parameter Reset - Siemens Albatros2 RVS46 User Manual

Building and room model

Frost protection plant

Sensor state

Parameter reset

Plant diagrams

Siemens Schweiz AG
HVAC Products
Line no. Operating line
6110 Time constant building
When the outside temperature varies, the room temperature changes at different rates,
depending on the building's thermal storage capacity.
The above setting is used to adjust the response of the flow temperature setpoint to
varying outside temperatures.
• Example:
> 20
The room temperature will respond more slowly to outside temperature variations.
10 - 20
This setting can be used for most types of buildings.
< 10
The room temperature will respond more quickly to outside temperature variations.
Line no. Operating line
6120 Frost protection plant
The pumps are activated depending on the current outside temperature, even if there
is no request for heat.
Outside temperature
...-4 °C
-5...1.5 °C
1.5°C...
ON
-6 -5 -4 -3
Line no. Operating line
6200 Save sensors
At midnight, the basic unit saves the states at the sensor terminals.
If, after storage, a sensor fails, the basic unit generates an error message.
This setting is used to ensure immediate saving of the sensors. This becomes a
requirement when, for instance, a sensor is removed because it is no longer needed.
Line no. Operating line
6205 Reset to default parameters
All parameters can be reset to their default values. Exempted from this are the following
Time of day
operating pages:
Setpoint manual control
as well the
Line no. Operating line
6212 Check no. heat source 1
6215 Check no. storage tank
6217 Check no. heating circuits
User Manual
The settings in detail
Pump
Continuously on
On for 10 minutes at 6-hour intervals
Continuously off
takt
-2 -1 0 1
date operator unit
and ,
.
Diagram
ON
takt
OFF
OFF
2 3 4
TA °C
radio and all time programs
,
CE1U2353en
22. November 2006
,
77/100