Xerox 1186 User Manual page 51

SOFTWARE INSTALLATION
5. Aher the sysout has been copied and expanded,
you will be asked if you want to boot the copied
sysout. Press the right mouse button to abort.
6. Then select the Quit! command by pressi ng the
left mouse button. 'vVhen the Lisp System Toois
window reappears, select Boot! by pressing the left
mouse button.
7. When the boot icons appear on the screen, press
the Fl key. This will boot the sysout you just copied.
In one or two minutes, the Interlisp-D window
environment will appear. Go to Procedure 6,
Initializing Lisp.
5) Re-Installing a Lisp Sysout from the Rigid Disk
Prerequisites:
• Assumes Initial Microcode and Lisp Microcode
were installed and the System Tools are running.
• Assumes there is an unused and unexpanded Lisp
Sysout on the Lisp2 vol ume.
• Assumes the boot icons are displayed on the
screen (if the icons are not displayed, press the B
Reset button).
Steps for Re-Installing a Lisp Sysout from the Rigid Disk
a. Do an alternate F 1 boot by pressi ng the F 1 key
and immediately pressing the zero key.
Note: The zero key must be pressed while the
4-digit cursor code reads 149.
The 4-digit cursor code will count 149, 199, 910,920,
940, 990 then a bouncing white box will appear. If
the cursor code goes to a number higher than 990,
the alternate F 1 boot has failed. Press the B Reset
button and try agai n.
XEROX 1186 USER'S GU IDE
43